Ultimarc ServoStik Upgrade Kit

You can upgrade an Ultimarc J-Stik or Sanwa TM8/UM8 to a ServoStik with this kit.

*Required* Ultimarc ServoStik Control Board (Supports 2 joysticks)

Contains:

• Servo
• 4 Screws
• 4 Washers
• 4 Springs

Installation:

• Remove the plate & screws from the joystick
• Install new plate, then washers, springs, and screws
• Tighten screws until they stop, plate will be held in place by the springs
• See the Ultimarc ServoStik Joystick product page for installation of the servo and control board